Using `jive setup`

Use jive setup after you install the RPM. It provides system requirements and suggestions for configuring your Jive instance.

As you go through the jive setup, it provides suggestions for your configuration. Use the command-line output to update your configurations. After you make changes, run jive setup until you get the setup ok message.

Note: Running jive start automatically runs jive setup before starting jive unless you disable it as shown in the following section.

Disabling `jive setup`

You can skip jive setup by doing one of the following:

Tell the start process to not use setup, and only start Jive:
```
jive start --skip-setup
```
Set the main.skip_setup startup property to true:
```
jive set main.skip_setup true 
```

Using jive setup

Disabling jive setup

Using `jive setup`

Disabling `jive setup`